Size Guide

Two measurements decide whether a strap fits: the lug width of your watch, and your wrist circumference. Get those right and everything else follows.

Lug width

This is the gap between the two lugs, where the strap sits. Measure it in millimetres with a ruler or a caliper, from the inside of one lug to the inside of the other. Common sizes are 18, 19, 20, 21 and 22 mm. It must be exact. A 20 mm strap will not go into a 19 mm gap, and a 19 mm strap in a 20 mm gap will rattle.

Wrist size

Wrap a tape measure, or a strip of paper you then measure, around your wrist just where you wear the watch. Note the number in centimetres or inches.

Curved end or straight

Look at the lug opening from the side. If the case curves inwards where the strap meets it, as on most divers and cushion cases, choose Curved End: Yes so the leather follows that curve with no gap. If the opening is a plain straight bar, choose No.

If you cannot tell, email us the watch model before you order. This is the single most common thing people get wrong, and it is the easiest to check in advance.

Buckle

A standard pin buckle is the usual choice and suits any watch. A butterfly clasp folds away under the wrist, so the strap has no visible buckle and does not bend sharply over time. It costs a little more and suits dressier watches.

Still unsure

Send your watch model and wrist measurement to support@orlanox.com. Every strap is cut to order, so it is worth a minute to get this right before we cut.